BigC
GBClever but greatly overpriced First the good - it's a clever concept. The bad - poor retainers that loosen easily, the stems are hard to bend, shipping boxes are flimsy and will set you back at least an hour to bend them back into shape, they send you exactly what you need so don't make any mistakes. I recommend you spend a fraction of what they want by getting chicken wire at your local hardware store and fashion some retainers with 16 gauge wire.
Richard Furlong
GBManufacturer needs to address cheap plastic problem I have purchased several of the bird repellers and spiders; when they are not broken they actually work pretty well for me. the problem is that they all have broken - at the plastic housing around the spindle, or at the base. Super discouraging. there was very little wind. I wish this companywould address thier manufacturaing defect of the cheap plastic they use. I wrap the spindle housing with electrical tape to shore up the cheap quality stalks, but the last 2 just broke too. sigh
Steve Royalty
GBBeware Beware. I bought a 25 ft by 75 ft piece of the 3/4 inch netting. This was not 25x75. Each end tapered to a point and was in no mean cut square. I had a 26 x52 ft area to cover. this very difficult to install because of the way it was cut. I barley had enough to finish the job.
Stan Oken
GBLive on small pond that has a geese problem Live on small pond that is gaining population of Canadian Geese. Now have 14 on the yard constantly. Tried Bird B gone and did not have any effect. If it would have worked I have 90 homes in my development that would have all bought some. VERY DISAPPOINTING as it did not meet the advertising. And I wasted about $90.00 with the sprayer.
Bill P.
GBThe railing attachment is very poorly … The railing attachment is very poorly designed. The railing attachment for the worley bird is not strong enough to hold the the worly- bird upright when the wind is blowing. The threads on the railing attachment strip off when tightening it down enough to hold the worly-bird upright. As well, the railing attachment will not fit on an oblong boat rail. I suggest you redesign the railing attachment. The two I bought from you are unusable.