jamb nuts missing. I received the turbo and installed it. At 15 psi the waste gate would open. I called K T performance and explained to them the problem. The sent me a u-tube Visio on how to adjust the waste gate. After watching the vidio I was suppose to adjust the rod on the waste gate with the jamb nuts that where supped to be there. And using an air compressor with a psi regulator. There where no jamb nuts on the rod, so had to remove gate put nuts on and set psi on the gate. All of this after I had installed it, so had to take it back off. So if you buy a turbo don't do like I did and take for granted its assembled correctly. Also the length of time they give you to send in the warenty paperwork is not practical for the do it yourselfer .

Ford ZF Input Shaft Recently purchased repair kit for our 01 F450 with ZF trans. During clutch replacement we found Input shaft on trans worn at pilot. This kit it all you need. High quality. Inexpensive compared to alternative. Would recommend there products to anyone!!! Great job guys!

I'm doing a rebuild on my engine and … I'm doing a rebuild on my engine and these are factory replacement standard bearings just as the company says they are. The price was way better than buying from Ford obviously and was the best price around at the time when I purchased. I didn't pay any extra for shipping and my bearings showed up in about 4 days.

I'm not going to waste a lot of my time… I'm not going to waste a lot of my time because I already have with this company It's very simple they're unprofessional unorganized and constantly lie about the situation. People beware we all want good customer service these days this company is inadequate and cannot provide good customer service.

Ordering was easy and quick but took a … Ordering was easy and quick but took a little longer to get delivered than I expected. The real kicker was finding out I was responsible to pay for return shipping of the cores. I could have done without the t-shirt to help with shipping...